DTS 600/800 series garage motor

Add a remote to DTS 600/800 series garage motor

  1. Press CODE (K2), the Red dot will light up.
  2. Press and release a button on the transmitter, the Red dot will disappear.
  3. Press the same button again, the Red dot will flashand then be replaced by a II on the LED display.
  4. Transmitter is successfully programmed.
  5. Repeat from step 1 to code a maximum of 20 remotes.

To erase all the remotes from the DTS600/800 receiver, press and hold CODE (K2), the LED display dot will flash, keep holdingĀ  for approximately 8 seconds until the LED display flashes C. Release button. All transmitters are now deleted.